Google Pixel 9 Back Glass Replacement

Gerät: Google Pixel 9
Schwierigkeit: Mittel
Geschätzte Dauer: ⏱ 30 min

This repair guide was authored by the iFixit staff and hasn’t been endorsed by Google. Learn more about our repair guides here.

Follow this guide to replace a cracked or broken glass back cover on your Google Pixel 9.

You'll need replacement back glass adhesive to complete this repair.

Note: Any repair can compromise the water resistance of your phone. Retaining water resistance after the repair will depend on how well you reapply the rear cover adhesive.

Reparatur anfragen →

Lieber von uns ausführen lassen? Angebot innerhalb eines Werktages.

Werkzeuge

iFixit Opening Picks (Set of 6) Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Isopropyl Alcohol Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Microfiber Cleaning Cloths Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Spudger Verfügbarkeit: Bestellbar Im Shop ansehen →
Suction Handle Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →

Ersatzteile

Google Pixel 9 Rear Cover - Genuine Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Google Pixel 9 Rear Cover Adhesive - Genuine Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Precut Double-Sided Adhesive Card Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →

Anleitung

Prepare your Pixel for disassembly
Vorsicht: Caution Let your Pixel's battery drain below 25% before starting this repair. A charged lithium‑ion battery may catch fire if damaged.

Unplug all cables from your phone.

Completely power off your phone.

Hinweis: Note Press the power and volume up buttons at the same time to bring up the shutdown menu.
Adhesive information
Adhesive secures the perimeter of the back glass to the frame.

Vorsicht: Caution When separating the adhesive, don't insert your tool more than <strong>3 mm</strong> under the back glass to avoid damaging the internal components.

Hinweis: Note To help, measure and mark 3 mm from the tip of an opening pick with a permanent marker.

Hinweis: Note If your screen or back glass is badly cracked, a suction cup may not perfectly adhere.

Lay overlapping strips of packing tape over the glass to protect yourself and make disassembly easier. Ensure there's a smooth area near the bottom edge that's large and smooth enough for a suction cup to stick to.
Apply a suction handle
Place a suction handle at the bottom edge of the back glass, as close to the edge as possible.

Push down to attach the suction cup.
Insert an opening pick
Pull up on the suction handle with strong, steady force to create a small gap under the back glass.

Insert the tip of an opening pick into the gap.
Separate the back glass adhesive
Slide the opening pick back and forth along the bottom edge to separate the adhesive securing it.

Vorsicht: Caution Remember: don't insert the opening pick deeper than 3 mm.
Step 6
Slide the opening pick around the perimeter of the phone, slicing the rest of the adhesive.
Step 7
With most of the adhesive separated, lightly twist the opening pick at the bottom edge to lift the back glass up until you can grip it with your fingers.

Use the opening pick to separate any remaining sections of adhesive securing the back glass.
Remove the back glass
Remove the back glass.

Erinnerung: Reminder During reassembly:

Now is a good time to test your phone before sealing it up. Power it on and check that it works. Power it back down before you continue reassembly.

Follow this guide to apply new adhesive and install your back glass.