Google Pixel 9 Pro Rear Cover Replacement

Werkzeuge

• 3IP Torx Plus Bit Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• ESD Safe Blunt Nose Tweezers Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• iFixit Opening Picks (Set of 6) Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• iFixit Precision Bit Driver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• Isopropyl Alcohol Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• Microfiber Cleaning Cloths Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• Spudger Verfügbarkeit: Bestellbar Im Shop ansehen →
• Suction Handle Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• T3 Torx Screwdriver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →

Ersatzteile

• Google Pixel 9 Pro Rear Cover - Genuine Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• Google Pixel 9 Pro Rear Cover Adhesive - Genuine Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →

Anleitung

1. Safety precautions

   • 
   • 

   Unplug all cables and completely power down your phone.

2. Adhesive information

   • 
   • 
   • 

   Adhesive secures the perimeter of the rear cover to the frame.

3. Apply a suction handle

   • 
   • 

   Attach a suction handle to the bottom edge of the rear cover, as close to the edge as possible.

4. Insert an opening pick

   • 
   • 
   • 

   Pull up on the suction handle with strong, steady force to create a small gap under the rear cover.

   Insert the tip of an opening pick in the gap.

5. Separate the rear cover adhesive

   • 
   • 
   • 

   Slide your opening pick along the bottom edge to separate the adhesive securing it.

6. Step 6

   • 
   • 
   • 

   Slide your opening pick up the left edge and along the top edge to separate the adhesive.

7. Step 7

   • 
   • 
   • 

   Slide your pick down the right edge to separate the remaining adhesive.

8. Prop up the rear cover

   • 
   • 
   • 

   Use the suction handle to lift the left edge of the rear cover and swing it over the right edge, like opening the cover of a book.

   Prop up the rear cover with the suction handle so you can access the ribbon cable near the top right corner.

9. Remove the wireless charging assembly

   • 
   • 

   Use a Torx Plus 3IP screwdriver to remove the five screws securing the wireless charging assembly:

   Four 5.4 mm‑long screws

   One 1.5 mm‑long screw

10. Step 10

    • 
    • 
    • 

    Use tweezers or your fingers to remove the wireless charging assembly.

11. Disconnect the rear cover

    • 
    • 
    • 

    Insert the tip of an opening pick under the left edge of the rear cover press connector and pry straight up to disconnect it.

12. Remove the rear cover

    • 

    Remove the rear cover.

Abschluss

To reassemble your device, follow this guide.

To run a diagnostics test with the built-in Pixel Diagnostic tool, click here.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.