Google Pixel 9 Pro Wireless Charging Assembly Replacement
This repair guide was authored by the iFixit staff and hasn’t been endorsed by Google. Learn more about our repair guides here.
Follow this guide to replace the wireless charging assembly in your Google Pixel 9 Pro.
If your phone's wireless charging is intermittent or not charging at all, it may be time to replace the wireless charging assembly.
You'll need replacement rear cover adhesive to complete this repair.
Note: Any repair can compromise the water resistance of your phone. Retaining water resistance after the repair will depend on how well you reapply the rear cover adhesive.
Lieber von uns ausführen lassen? Angebot innerhalb eines Werktages.
Werkzeuge
-
3IP Torx Plus Bit Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
ESD Safe Blunt Nose Tweezers Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
iFixit Opening Picks (Set of 6) Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
iFixit Precision Bit Driver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
Isopropyl Alcohol Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
Microfiber Cleaning Cloths Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
Spudger Verfügbarkeit: Bestellbar Im Shop ansehen →
-
Suction Handle Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
T3 Torx Screwdriver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Anleitung
-
Safety precautions
Unplug all cables and completely power down your phone.
-
-
Adhesive information
Adhesive secures the perimeter of the rear cover to the frame.
-
-
Apply a suction handle
Attach a suction handle to the bottom edge of the rear cover, as close to the edge as possible.
-
-
Insert an opening pick
Pull up on the suction handle with strong, steady force to create a small gap under the rear cover.
Insert the tip of an opening pick in the gap.
-
-
Separate the rear cover adhesive
Slide your opening pick along the bottom edge to separate the adhesive securing it.
-
-
Step 6
Slide your opening pick up the left edge and along the top edge to separate the adhesive.
-
-
Step 7
Slide your pick down the right edge to separate the remaining adhesive.
-
-
Prop up the rear cover
Use the suction handle to lift the left edge of the rear cover and swing it over the right edge, like opening the cover of a book.
Prop up the rear cover with the suction handle so you can access the ribbon cable near the top right corner.
-
-
Remove the wireless charging assembly
Use a Torx Plus 3IP screwdriver to remove the five screws securing the wireless charging assembly:
Four 5.4 mm‑long screws
One 1.5 mm‑long screw
-
-
Step 10
Use tweezers or your fingers to remove the wireless charging assembly.
-
Abschluss
To reassemble your device, follow these instructions in reverse order.
To run a diagnostics test with the built-in Pixel Diagnostic tool, click here.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.