Nintendo Switch Lite Back Panel Replacement
Follow this guide to replace a cracked or damaged back panel on the Nintendo Switch Lite.
The Switch Lite uses JIS screws, but you can use a Phillips screwdriver in a pinch. Be very careful not to strip the screws. iFixit's Phillips bits are designed to be cross-compatible with JIS-style screws.
Lieber von uns ausführen lassen? Angebot innerhalb eines Werktages.
Werkzeuge
-
iFixit Opening Tool Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
Phillips #00 Screwdriver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
-
Tri-point Y00 Screwdriver Bit Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Anleitung
-
Remove the back panel screws
Use a Y00 screwdriver to remove the four 6.3 mm-long screws securing the back panel.
-
-
Remove the top and bottom back panel screws
Use a JIS 000 driver or an iFixit PH 000 driver to remove the following screws securing the back panel:
Two 3.6 mm-long screws on the top of the device
Two 3.6 mm-long screws on the bottom of the device
-
-
Release the clips securing the back panel
Insert an opening tool into the left speaker grille on the bottom of the device.
Twist the opening tool to release the clips securing the back panel.
-
-
Continue releasing the clips around the device
Slide the opening tool around the bottom-left corner to release the clips on the left side of the device.
-
-
Twist to release the clips
Insert an opening tool into the right speaker grille on the bottom of the device.
Twist the opening tool to release the clips.
-
-
Slide and pry around the corners
Slide and pry the opening tool around the bottom-right corner to release the clips on the right side of the device.
-
-
Step 7
Continue sliding and prying the opening tool along the gap on the top of the device to release the clips.
-
-
Remove the back panel
Lift the bottom edge of the back panel, opening it like a book.
Remove the back panel.
-
Abschluss
Compare your new replacement part to the original part. You may need to transfer remaining components or remove adhesive backings from the new part before installing.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Nintendo Switch Lite Answers community for help.