Xbox Series S Fan Replacement

Werkzeuge

• TR10 Torx Security Screwdriver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• TR8 Torx Security Screwdriver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
• Tweezers Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →

Ersatzteile

• Xbox Series S Fan Assembly Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →

Anleitung

1. Peel off the sticker coverings

   • 
   • 
   • 

   Use tweezers to peel off the two white screw covers located on the bottom corners of the back panel.

2. Remove the back panel screws

   • 

   Use a T8 Torx driver to remove the two 10 mm-long screws securing the back panel to the bottom panel.

3. Remove the bottom panel

   • 
   • 
   • 

   Slide the bottom panel horizontally toward the back of the console until it comes to a stop.

   Lift straight up and remove the bottom panel from the plastic case.

4. Remove the plastic case screws

   • 

   Use a T10 Torx driver to remove the seven 51 mm-long screws securing the chassis to the plastic case.

5. Remove the plastic case

   • 
   • 
   • 

   With the bottom of the Xbox facing you, pull the two bottom-rear corners of the plastic case away from each other.

   As you pull the corners apart, slide the back panel towards the bottom of the device. This releases the back panel from the plastic case.

6. Step 6

   • 
   • 
   • 

   Pull the bottom-left corner away from the chassis while swinging the chassis away from the plastic case.

   Remove the plastic case from the chassis.

7. Remove the power supply screws

   • 

   Use a T10 Torx driver to remove the seven 11.3 mm-long screws securing the power supply to the chassis.

8. Remove the upper chassis

   • 
   • 

   Flip the device over.

   Lift the upper chassis straight up to remove it.

9. Remove the power supply

   • 
   • 
   • 

   Lift the power supply straight up to disconnect it from the motherboard.

   Remove the power supply.

10. Remove the fan screws

    • 

    Use a T10 Torx driver to remove the two 11.3 mm-long screws securing the fan to the chassis.

11. Disconnect the fan

    • 
    • 

    Flip the device over.

    Use your fingers to pull and disconnect the fan connector from its motherboard socket.

12. Remove the fan

    • 
    • 

    Lift the fan straight up to remove it from the motherboard.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.