Xbox Series S Power Supply Replacement

Gerät: Xbox Series S
Schwierigkeit: Mittel
Geschätzte Dauer: ⏱ 20 min

Follow this guide to remove and replace the power supply on a Xbox Series S.

Reparatur anfragen →

Lieber von uns ausführen lassen? Angebot innerhalb eines Werktages.

Werkzeuge

TR10 Torx Security Screwdriver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
TR8 Torx Security Screwdriver Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Tweezers Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →

Ersatzteile

Microsoft Xbox Series S Model 1883 (12 digit serial number) Power Supply Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →
Microsoft Xbox Series S Model 1883 (14 digit serial number) Power Supply - Genuine Verfügbarkeit: Externe Bezugsquelle Bei iFixit kaufen →

Anleitung

Peel off the sticker coverings
Vorsicht: Caution Before you start this guide, turn off the Xbox and unplug any cables from it.

Use tweezers to peel off the two white screw covers located on the bottom corners of the back panel.
Remove the back panel screws
Use a T8 Torx driver to remove the two 10 mm-long screws securing the back panel to the bottom panel.

Hinweis: Note Throughout this repair, <a href="https://www.ifixit.com/en-eu/products/magnetic-project-mat" class="product-link">keep track of each screw</a> and make sure it goes back exactly where it came from.
Remove the bottom panel
Slide the bottom panel horizontally toward the back of the console until it comes to a stop.

Hinweis: Note This slides the clips out of the slots on the plastic case.

Lift straight up and remove the bottom panel from the plastic case.
Remove the plastic case screws
Use a T10 Torx driver to remove the seven 51 mm-long screws securing the chassis to the plastic case.
Remove the plastic case
With the bottom of the Xbox facing you, pull the two bottom-rear corners of the plastic case away from each other.

As you pull the corners apart, slide the back panel towards the bottom of the device. This releases the back panel from the plastic case.

Hinweis: Note The back panel should now settle on top of the clips on the back of the plastic case.

Hinweis: Note The back panel is permanently attached to the aluminum chassis.

Vorsicht: Caution Do not attempt to fully remove the chassis from the plastic case with this technique. You may risk breaking your case.
Step 6
Pull the bottom-left corner away from the chassis while swinging the chassis away from the plastic case.

Hinweis: Note You may need to lift the chassis to free it from the clips on the bottom-front of the plastic case during this process.

Remove the plastic case from the chassis.
Remove the power supply screws
Use a T10 Torx driver to remove the seven 11.3 mm-long screws securing the power supply to the chassis.
Remove the upper chassis
Flip the device over.

Lift the upper chassis straight up to remove it.
Remove the power supply
Lift the power supply straight up to disconnect it from the motherboard.

Remove the power supply.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.