Xbox Series X Back Panel Replacement

Gerät
Xbox Series X
Schwierigkeit
Mittel
Geschätzte Dauer
⏱ 10 min
Xbox Series X Back Panel Replacement

Use this guide to remove or replace the back panel on an Xbox Series X.

Before you begin, completely power down and unplug all cables from your console. Remember to follow general electrostatic discharge (ESD) safety procedures while repairing your console.

Reparatur anfragen →

Lieber von uns ausführen lassen? Angebot innerhalb eines Werktages.

Werkzeuge

Anleitung

  1. Uncover the back panel screws

    • Uncover the back panel screws
    • Uncover the back panel screws

    Use a pair of tweezers to remove the sticker hiding the first screw on the back panel, near the base.

  2. Step 2

    • Repair step image
    • Repair step image
    • Repair step image

    Use a pair of tweezers or a sharp blade to peel up a corner of the large sticker on the back panel. Use your fingers to peel it farther, just enough to reveal the second screw.

  3. Remove the back panel screws

    • Remove the back panel screws

    Use a T8 Torx driver to remove the two 7.4 mm‑long screws securing the back panel.

  4. Unclip the back panel

    • Unclip the back panel
    • Unclip the back panel
    • Unclip the back panel

    Insert the flat end of a spudger into the gap between the back panel and the shell, near the left side of the base.

    Pry up the back panel to release it from the locking clips.

  5. Step 5

    • Repair step image
    • Repair step image

    Insert the flat end of a spudger into the gap between the back panel and the shell, near the right side of the base.

    Pry up the back panel to release it from the locking clips.

  6. Remove the back panel

    • Remove the back panel
    • Remove the back panel
    • Remove the back panel

    Grip the back panel at the opening you just created and pull it up and away from the shell to unclip the long edges.

  7. Step 7

    • Repair step image
    • Repair step image
    • Repair step image

    Tilt the back panel up and pull it away from the top edge of the shell to release it from the gap.

    Remove the back panel.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Xbox Series X Answers community for help.

Inhalt von iFixit unter der Lizenz CC BY-NC-SA 3.0. Übersetzung und Bereitstellung durch MB-IT Services.